A+B Sclerosant

 Method of use:
   1, mix the AB liquid 1:1 ratio.
  2、After the second exposure of the screen plate, use the sponge or soft cloth to spread the mixed hard film agent evenly on both sides of the screen plate, pay attention not to flow over a large area.
  3, placed for 1 minute, so that the hard film agent will screen plate penetration.
  4、Blow off the excess hardfilm agent with air, or use a clean soft cloth to absorb the excess hardfilm agent.
  Note: If there is excess hard film agent left on the surface of the screen plate, it will make the photographic film layer form a film surface, affecting the printing effect.
  5, the screen into the 40 ~ 60 oven drying more than 30 minutes, if the drying is not thorough or the temperature is too low, the effect will be weakened.
  6、After drying, rinse the screen plate with water for better effect.